DRILL BIT SHARPENER MACHINE -SG TYPE
DRILL BIT SHARPENER MACHINE -SG TYPE
1.Drill tightened design with bearing device.
2.Adjustable trimmimg angle.
3.Adjustable secondary clearance angle.
Patent number:
ZL 200820153366.2,
Japan 3151952,
M 356596,
Nr 202008013817.5
| Type | Capacity | Motor / Speed | Weight | L x W x H |
|---|---|---|---|---|
| SG-313 | 3mm - 13mm | 200 w / 4200 rpm | 13 kgs | 345*175*200 |
| Axial Angles | 140° | Power | AC 110V / AC 220V 50 / 60 HZ | |
| Standard Accessories | |
|---|---|
| Power Wires | 1 SET |
| Fuse | 1 SET |
| Hex. Wrench | 4mm / 5mm *1 |
| Diamond Wheel | CBN250#、CBN400#(5mm↓) |
| ER20 Collet Chuck | 1 SET |
| ER20 Collet | 3-13mm*11pcs |
| Standard Accessories | |
|---|---|
| ER20 Collet | 3.5、4.5、5.5、6.5、7.5、8.5、9.5、10.5、11.5、12.5mm |
| Diamond Wheel | SDC300# |
Safety Instructions
Names of Components
Preparation Before Grinding Drill
Drill Grinding Procedures
Replacing The Grinding Wheel
Maintenance After Operation
Recommend
3 SLANT DRILL BIT SHARPENER MACHINE -MD TYPE
3 SLANT DRILL BIT SHARPENER MACHINE -MD TYPE
1.Drill tightened design with bearing device.
2.Adjustable trimming angle.
3.Adjustable secondary clearance angle.
Patent number:
ZL 200900174158.5,
M369817
DRILL BIT SHARPENER MACHINE -DM TYPE
DRILL BIT SHARPENER MACHINE -DM TYPE
- Loosen the side knob (B1) and open the side cover (B2).
- Use a 4mm hexagon wrench to loosen the screw (B3), unscrew it counter clockwise.
- Replace with a new diamond grinding wheel and tighten the screw after the wheel is installed.
- Be sure to close the side cover (B2) properly and to fasten the side knob (B1).
Please DO NOT switch on the machine BEFORE
- The diamond wheel screw (B3) is tightly screwed.
- The side cover (B2) is properly closed.
- The right knob (B1) is fully fastened.
※ In case of any hazard occurring, please make sure that the above measures are followed strictly.
※ The machine has an automatic Power-off device to ensure operator’s safety. Power supply will be cut-off immediately when the cover is opened.