CUTTING OFF MACHINE-CM-316
CUTTING OFF MACHINE-CM-316
Patent number:
ZL 200920147543.0,
M362076
| TYPE | Capacity | Motor / Speed | Weight | L x W x H |
|---|---|---|---|---|
| CM-316 | 3mm - 16mm | 600 w / 6000 rpm | 13.5 kgs | 340*210*210 |
| 電源 | AC 110V / AC 220V 50 / 60 HZ | |||
| Standard Accessories | |
|---|---|
| Power Wires | 1 SET |
| Fuse | 2 SET |
| Hex Wrench | 4mm / 5mm / 10mm *1 |
| Handle | 1 SET |
| Diamond Wheel | SDC100#*1 |
| Optional Accessories | |
|---|---|
| Diamond Wheel | SDC100#*1 |
| Water Box | - |
Recommend
ENDMILL HELIX RE-SHARPENING EH TYPE
ENDMILL HELIX RE-SHARPENING EH TYPE
- The universal tool & cutter grinder Model EH-832 is versatile in operation without requiring special skills. All milling cutters, endmills, shell endmills,staggered tooth cutters, rough endmills, countersinks (2 flutes, 4 flutes) and the angle of endmill helix can sharpen 2, 3, 4, 5, 6 flutes.
- The Model EH-832 is designed to sharpen HSS and carbide toolings in small and medium quantities.
- In one chucking operation, the machine can perform the grinding of the rake angle of the flute, clearance angle on the periphery and the end of the tool.
- A few seconds set up time for helix angle.
- Due to the backlash free operation, spiral toothed, solid carbide or carbide tipped milling cutters can be ground with high accuracy thus far only achieved by CNC grinders.
- The heavy duty compound slides and one piece cast-iron base provide extra rigidity and minimize vibration.
ENDMILL SHARPENER MACHINE -GH TYPE
ENDMILL SHARPENER MACHINE -GH TYPE
For End Mill Re-sharpening, 2,3 and 4 Flutes Precision, Efficiency, Easy Operation, Short Processing Time, Grinding Diameter from GH413-4～13mm, GH1225-12~25mm
- High Efficiency, High Quality Grinding Slip, Good Grinding Results
- Quality Assurance : 0.02mm
- Easy Operation, and Fast for Convenience
DRILL BIT SHARPENER MACHINE -DM TYPE
DRILL BIT SHARPENER MACHINE -DM TYPE
- Loosen the side knob (B1) and open the side cover (B2).
- Use a 4mm hexagon wrench to loosen the screw (B3), unscrew it counter clockwise.
- Replace with a new diamond grinding wheel and tighten the screw after the wheel is installed.
- Be sure to close the side cover (B2) properly and to fasten the side knob (B1).
Please DO NOT switch on the machine BEFORE
- The diamond wheel screw (B3) is tightly screwed.
- The side cover (B2) is properly closed.
- The right knob (B1) is fully fastened.
※ In case of any hazard occurring, please make sure that the above measures are followed strictly.
※ The machine has an automatic Power-off device to ensure operator’s safety. Power supply will be cut-off immediately when the cover is opened.